Toshiba GR200 Series Instruction Manual page 804

14. PIXIT FOR CONTROL MODEL(Continued)
ID Ed
How to force a "test-not-ok" respond with
Operate request
Ct12 1,2
Which origin categories are supported /
accepted
Ct13 1,2
What happens if the orCat value is not
supported or invalid
Ct14 1,2
Does the IED accept a SelectWithValue /
Operate with the same control value as the
current status value
Ct15 1,2
Is this behavior configurable
Does the IED accept a select/operate on the
same control object from 2 different clients at
the same time
Ct16 1,2
Description
- 790 -
Value / Clarification
DOns, SBOns, DOes:
[Example1]
Set orCat as unsupported value
-> Cause AddCause as "Not-
supported(1)"
[Example2]
Set ctlCat same as stVal
-> Cause AddCause as "Position-
reached(5)"
SBOes: (Only Ed1)
Same as above. Or,
[Example3]
Set Oper parameters as different
parameter from the parameter of
SelectWithVal
-> Cause AddCause as "Parameter-
change-in-execution (6)"
N bay-control
Y station-control
Y remote-control
N automatic-bay
Y automatic-station
Y automatic-remote
N maintenance
N process
maintenance (7): N
process (8): N
DOns, SBOns, DOes, SBOes:
"test-not-ok" IED respond
DOns, SBOns, DOes, SBOes: N
Fixed
DOns: N
SBOns: N
DOes: N
SBOes: N
Note:
Commands are refused until
the new position is not reached
or a timeout does not occur.
Centralized GRB200
(Soft: 030, 031, 032, 033, 034)
6F2S1931 (0.20)
(PIXIT Ed.1&Ed.2)