Toshiba GR200 Series Instruction Manual page 697

I/O setting sub-menu
The "I/O Setting" sub-menu is used to set or change settings for the following items:
(i) AC Analog Input
(ii) Binary Input
(iii) Binary Output
(iv) LED
This section explains the details of the setting method.
AC analog input
(i)
For the AC analog inputs in the VCT module, the user can configure a ratio for each AC analog
channel. With regard to the ratio, the user can key the value of the ratio from the sub-menu.
Selection of ratio: For example, Figure 4.2-1 shows how the channel selection
is made for the AC analog input on a VCT module (AI#1 = VCT#1). Move the
cursor by pressing keys ▲ and ▼. Then, press key ►to go to the next level in
the hierarchy.
AC Analog Input
10:48
AI#1
AI#2
Note: This screen is a sample. The AI numbers displayed are dependent upon the
configuration of VCT modules in each IED.
Binary input
(ii)
All binary input circuits provided in the IED are user-configurable; the user can set common
programmable logic (CPL) for each binary input circuit. (For more information regarding CPL,
1/2
>
►
>
Figure 11.6-1 AC analog input screen
- 683 -
AI#1
10:48 1/12
CH1 >
CH2 >
CH3 >
CH4 >
CH5 >
CH6 >
►
AI#1
10:48 1/2
AI1_Ch1_Ratio +
2000.000
Centralized GRB200
(Soft: 030, 031, 032, 033, 034)
6F2S1931 (0.20)