Toshiba GR200 Series Instruction Manual page 231

Counter function for the general (GCNT)
When a signal is generated externally and the signal is received by generic counter function
(GCNT), the GCNT function can count their signal transitions. Figure 3.7-1 shows signals are
generated repeatedly. For example, if the number of generated signals should be reported, the
GCNT function counts the number of the signal transitions; the function can report them. A
binary input-circuit (BI) is used to receive the signal, when a device (external object) reports
its state.
Changes in device status
(e.g., operations of 43S)
Operations at the local or
remote-end
(e.g., issuing commands)
Changes in a function
status
(e.g., function operations)
Count objects
─────────────────────────────────────────────────────────────────
Note: The implementation of particular features is dependent upon the selection of
hardware and the configuration of functions. Several IED models do not support certain
features. To determine whether a particular feature has been implemented within an IED,
identify the IED ordering number; and check the order number for the "G&T position" whilst
referring to the comparison table below. For more information, see Appendix: Ordering.
Table 3.7-1 Comparative table in respective ordering numbers
Sec. Feature
– Main features
: Applicable

Closed/ Open signals
BI
Control commands
Status signals
Signals generated
Figure 3.7-1 Reception of signals at GCNT functions
30 31
 
NA: Not applicable
Inputs
540001 800E 01E DE 0
540001 800E 06E DE 0
540001 800E 20E DE 0
Ordering No. at "G&T"
32 33 34
    
- 217 -
6F2S1931 (0.20)
GCNT01_ CNT_ VAL
320E 011D20
GCNT01
GCNT01_ PLC_ SGNL
GCNT06_ CNT_ VAL
320E 061D20
GCNT06
GCNT06_ PLC_ SGNL
GCNT32_ CNT_ VAL
320E 201D20
GCNT32
GCNT32_ PLC_ SGNL
GCNT functions
Note

Centralized GRB200
(Soft: 030, 031, 032, 033, 034)