Table of Contents
Advertisement
DSP96002 Bus Master
DMA Destination
DMA Request
Bus Master
Read Bus Cycle
into Memory
where this pin is defined as a DMA service request input. When
troller transfers the data word from the external address that selects the RX register in the slave's HI to a
master memory location. After RX is read (negating
the HI HTX register, setting HTDE and RXDF. Setting RXDF causes
In the slave's DMA Controller, HTDE is defined as a DMA service request signal. When HTDE is asserted,
the slave's DMA Controller initiates a data transfer from the slave memory to the HTX register, keeping the
register full for further data transfers.
7.4.20
External DMA Controller to DSP96002 Data Transfers - Examples
This section presents examples showing the use of the HI and the on-chip DMA Controller for data transfers
between a DSP96002 and an external DMA Controller. The external DMA Controller is the bus master and
the DSP96002 is the bus slave. The external DMA Controller accesses the DSP96002 HI without supplying
an address to select a HI register. Note that the HI is programmed to work in the DMA Mode (DMAE=1).
7.4.20.1
Data Write Using the DSP96002 On-Chip DMA Controller
This example outlines the steps that an external DMA Controller, the bus master, takes to transfer data to
a DSP96002 bus slave, thorough the slave's HI. The on-chip DMA Controller of the DSP96002 is used to
locally transfer data between the HI and the DSP96002 memory without interfering with core processing.
The TREQ and RREQ bits in the ICS register must be programmed to define the direction of data transfer
as being from the external DMA Controller to the HI (TREQ=1, RREQ=0). The TYEQ bit in the ICS register
7 - 34
—
—
–
I
R
Q
space
slave
S1, S0
select
address
A0–A31
decode
—
–
T
A
—
–
T
S
—
R/
W
data
Figure 7-18. DSP96002 to DSP96002 Data Read
DSP96002 USER'S MANUAL
full
V
cc
—
–
H
R is asserted, the master DMA Con-
—
–
H
R), the HI may transfer the next data word from
—
H
DSP96002 Bus Slave
DMA Source
—
–
DMA Request
H
R
—
–
Memory
H
S
DMA Transfer
—
–
H
A
Receive Data Full
(RXDF=1)
A2–A5
—
–
T
S
—
R/
W
D0–D31
Host Data Empty
(HTDE=1)
–
R to be asserted if RREQ is set.
MOTOROLA
Host
Advertisement
Table of Contents
