Motorola DSP96002 User Manual page 749

S1
E1
11 Bits
put operand. These cycles are used to normalize the input operand. The original value of the operand in the
source register is not affected. During the IEEE mode procedure all activity of the chip is suspended
until the input operands have been normalized. When denormalized output results are detected, each
denormalized output result is normalized (one additional instruction cycle). There is no extra cycle penalty
for entering the IEEE mode procedure when normalizing output results.
C.2 FIXED-POINT NUMBER STORAGE AND ARITHMETIC
C.2.1 General
Integer operand sizes are defined as follows:
1. Byte: 8 bits long
2. Short word: 16 bits long
3. Word: 32 bits long
4. Long word: 64 bits long
The operand size for each instruction is either explicitly encoded in the instruction or implicitly defined by
the instruction.
C.2.2 Integer Storage Format in Memory
The DSP96002 supports four integer memory data formats:
1. Signed word integer: 32 bits wide, two's complement representation. This storage format can
be used in either X and/or Y data memory space.
2. Signed Long Word Integer: 64 bits wide, two's complement representation. This storage format
C-26
Add exponents
and subtract bias
11 Bits
ED
D
DSP96002 USER'S MANUAL
S2
E2
11 Bits
MOTOROLA