Spi Status Register (S0Spsr - 0Xe002 0004); User Manual - Philips LPC2101 User Manual

Philips Semiconductors
Volume 1
Table 141: SPI Control Register (S0SPCR - address 0xE002 0000) bit description
Bit
7
11:8
15:12

12.4.2 SPI Status Register (S0SPSR - 0xE002 0004)

The S0SPSR register controls the operation of the SPI0 as per the configuration bits
setting.
Table 142: SPI Status Register (S0SPSR - address 0xE002 0004) bit description
Bit
2:0
3
4
5
6
7

User manual

Symbol Value Description
SPIE Serial peripheral interrupt enable.
0 SPI interrupts are inhibited.
1 A hardware interrupt is generated each time the SPIF or
MODF bits are activated.
BITS When bit 2 of this register is 1, this field controls the
number of bits per transfer:
1000 8 bits per transfer
1001 9 bits per transfer
1010 10 bits per transfer
1011 11 bits per transfer
1100 12 bits per transfer
1101 13 bits per transfer
1110 14 bits per transfer
1111 15 bits per transfer
0000 16 bits per transfer
- Reserved, user software should not write ones to
reserved bits. The value read from a reserved bit is not
defined.
Symbol Description
- Reserved, user software should not write ones to reserved bits.
The value read from a reserved bit is not defined.
ABRT Slave abort. When 1, this bit indicates that a slave abort has
occurred. This bit is cleared by reading this register.
MODF Mode fault. when 1, this bit indicates that a Mode fault error has
occurred. This bit is cleared by reading this register, then writing
the SPI0 control register.
ROVR Read overrun. When 1, this bit indicates that a read overrun has
occurred. This bit is cleared by reading this register.
WCOL Write collision. When 1, this bit indicates that a write collision
has occurred. This bit is cleared by reading this register, then
accessing the SPI data register.
SPIF SPI transfer complete flag. When 1, this bit indicates when a SPI
data transfer is complete. When a master, this bit is set at the
end of the last cycle of the transfer. When a slave, this bit is set
on the last data sampling edge of the SCK. This bit is cleared by
first reading this register, then accessing the SPI data register.
Note: this is not the SPI interrupt flag. This flag is found in the
SPINT register.
Rev. 01 — 12 January 2006
UM10161
Chapter 12: SPI
Reset
value
0
0000
NA
Reset value
NA
0
0
0
0
0
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
163