Settings; Diagnostics; Programmable Relay Output - ABB ACS350 User Manual

104

Settings

Parameter
Group
Group
Group
Group
Group
2013,
2109
2201
2209
3003
Group
3601
3622
4010/4110/4210
4022/4122
4027
4228
Group

Diagnostics

Actual value
0160
0414

Programmable relay output

The drive has one programmable relay output. By means of a parameter setting it is
possible to choose what information to indicate through the relay output: Ready,
running, fault, alarm, etc. The update time for the relay output is 2 ms.
It is possible to write a value to a relay output through a serial communication link.
Settings
Parameter
Group
8423
Diagnostics
Actual value
0134
0162
Program features
10 START/STOP/DIR
11 REFERENCE SELECT
12 CONSTANT SPEEDS
16 SYSTEM CONTROLS
19 TIMER & COUNTER
2014
35 MOTOR TEMP MEAS
84 SEQUENCE PROG
14 RELAY OUTPUTS
Additional information
DI as start, stop, direction
DI in reference selection, or reference source
DI in constant speed selection
DI as external Run Enable, fault reset or user macro change
signal
DI as timer or counter control signal source
DI as torque limit source
DI as external emergency stop command source
DI as acceleration and deceleration ramp selection signal
DI as zero ramp force signal
DI as external fault source
DI in motor temperature measurement
DI as timed function enable signal source
DI as booster activation signal source
DI as PID controller reference signal source
DI as sleep function activation signal in PID1
DI as PID1 parameter set 1/2 selection signal source
DI as external PID2 function activation signal source
DI as sequence programming control signal source
Additional information
DI status
DI status at the time the latest fault occurred
Additional information
RO value selections and operation times
RO control with sequence programming
Additional information
RO Control Word through fieldbus control
RO status