ABB ACS350 User Manual page 55

ID RUN WITH THE BASIC CONTROL PANEL
Change parameter 9910
setting by pressing
If you want to monitor actual values during the ID Run, go to
the Output mode by pressing
there.
Press to start the ID Run. The panel keeps switching
between the display that was shown when you started the ID
Run and the alarm display presented on the right.
In general, it is recommended not to press any control panel
keys during the ID Run. However, you can stop the ID Run at
any time by pressing
After the ID Run is completed, the alarm display is not shown
any more.
If the ID Run fails, the fault display presented on the right is
shown.
ID RUN WITH THE ASSISTANT CONTROL PANEL
Change parameter 9910
setting by pressing SAVE
If you want to monitor actual values during the ID Run, go to
the Output mode by pressing
there.
Press to start the ID Run. The panel keeps switching
between the display that was shown when you started the ID
Run and the alarm display presented on the right.
In general, it is recommended not to press any control panel
keys during the ID Run. However, you can stop the ID Run at
any time by pressing
After the ID Run is completed, the alarm display is not shown
any more.
If the ID Run fails, the fault display presented on the right is
shown.
ID RUN to 1 (ON). Save the new
.
repeatedly until you get
.
ID RUN to 1 (ON). Save the new
.
EXIT
repeatedly until you get
.
9910
LOC
PAR
LOC
PAR
LOC
OUTPUT
A2019
LOC
F0011
LOC
LOC PAR EDIT
9910 ID RUN
ON
[1]
CANCEL 00:00
LOC
0. 0 Hz
0. 0 A
0. 0 %
DIR 00:00
LOC
ALARM
ALARM 2019
ID run
00:00
LOC FAULT
FAULT 11
ID RUN FAIL
00:00
Start-up, control with I/O and ID Run
55
FWD
1
SET FWD
00
.
Hz
FWD
FWD
FWD
SAVE
50.0Hz
MENU