ABB ACS350 User Manual page 47

MANUAL ENTRY OF START-UP DATA (parameter group 99)
If you have an Assistant Control Panel, select the language
(the Basic Control Panel does not support languages). See
parameter 9901 for the values of the available language
alternatives.
The general parameter setting procedure is described below for the Basic
Control Panel. You find more detailed instructions for the Basic Control Panel
on page 63. Instructions for the Assistant Control Panel are on page 74.
The general parameter setting procedure:
1. To go to the Main menu, press
otherwise press repeatedly until you see MENU at the bottom.
keys /
2. Press
3. Find the appropriate parameter group with
.
4. Find the appropriate parameter in the group with
5. Press and hold for about two seconds until the parameter value is
shown with under the value.
SET
6. Change the value with keys
you keep the key pressed down.
7. Save the parameter value by pressing
Select the application macro (parameter 9902). The general
parameter setting procedure is given above.
The default value 1 (ABB STANDARD) is suitable in most cases.
Select the motor control mode (parameter 9904).
1 (VECTOR:SPEED) is suitable in most cases. 2 (VECTOR:TORQ) is
suitable for torque control applications. 3 (SCALAR:FREQ) is recommended
• for multimotor drives when the number of the motors connected to the
drive is variable
• when the nominal current of the motor is less than 20% of the nominal
current of the drive
• when the drive is used for test purposes with no motor connected.
if the bottom line shows OUTPUT;
until you see "PAr" and press
keys
keys
/
. The value changes faster while
.
REM
9901 LANGUAGE
[0]
CANCEL
REM
. REM
/
and press
REM
/
.
REM
REM
REM
REM
REM
REM
Start-up, control with I/O and ID Run
47
PAR EDIT
ENGLISH
00:00 SAVE
rEF
MENU FWD
-01-
PAR FWD
2001
PAR FWD
2002
PAR FWD
1500
rpm
PAR SET FWD
1600
rpm
PAR SET FWD
2002
PAR FWD
9902
PAR FWD
9904
PAR FWD