Mounting The Drive; Mount The Drive - ABB ACS350 User Manual

Mounting the drive

Mount the drive

Note: Make sure that dust from drilling does not enter the drive during the
installation.
With screws
1. Mark the locations for the holes using e.g. the mounting template cut out from the
package. The locations of the holes are also shown in the drawings in chapter
Dimensions. The number and location of the holes used depend on how the drive
is mounted:
a) back mounting (frame sizes R0...R4): four holes
b) side mounting (frame sizes R0...R2): three holes; one of the bottom holes is
2. Fix the screws or bolts to the marked locations.
3. Position the drive onto the screws on the wall.
4. Tighten the screws in the wall securely.
On DIN rail
1. Click the drive to the rail as shown in Figure a below. To detach the drive, press
the release lever on top of the drive as shown in Figure b.
a
located in the clamping plate.
b
Mechanical installation
27