Parameter Mode - ABB ACS350 User Manual

Parameter mode

In the Parameter mode, you can:
• view and change parameter values
• select and modify the signals shown in the Output mode
• start, stop, change the direction and switch between local and remote control.
How to select a parameter and change its value
Step Action
1. Go to the Main menu by pressing
otherwise by pressing
2. If the panel is not in the Parameter mode ("PAr" not visible), press key
or
shows the number of one of the parameter groups.
3. Use keys
4. Press . The display shows one of the parameters in the selected
group.
5. Use keys
6. Press and hold
value of the parameter with
value is now possible.
Note: When
SET
simultaneously changes the displayed value to the default value of the
parameter.
7. Use keys
changed the parameter value,
• To save the displayed parameter value, press
• To cancel the new value and keep the original, press
if you are in the Output mode,
repeatedly until you see MENU at the bottom.
until you see "PAr" and then press
and to find the desired parameter group.
and to find the desired parameter.
for about two seconds until the display shows the
underneath indicating that changing of the
SET
is visible, pressing keys
and to select the parameter value. When you have
starts flashing.
SET
. The display
and
.
.
Display
rEF
LOC
MENU FWD
PAr
LOC
MENU FWD
-01-
LOC
PAR FWD
-11-
LOC
PAR FWD
1101
LOC
PAR FWD
1103
LOC
PAR FWD
1
LOC
PAR SET FWD
2
LOC
PAR SET FWD
1103
LOC
PAR FWD
Control panels
63