I/O Settings Mode - ABB ACS350 User Manual

84

I/O Settings mode

In the I/O Settings mode, you can:
• check the parameter settings related to any I/O terminal
• edit the parameter setting. For example, if "1103: REF1" is listed under Ain1
(Analog input 1), that is, parameter
change its value to e.g. AI2. You cannot, however, set the value of parameter
1106
• start, stop, change the direction and switch between local and remote control.
How to edit and change parameter settings related to I/O terminals
Step Action
1. Go to the Main menu by pressing
EXIT
by pressing
2. Go the I/O Settings mode by selecting I/O SETTINGS on the menu with keys
and
3. Select the I/O group, e.g. DIGITAL INPUTS, with keys
SEL
press . After a brief pause, the display shows the current settings for the
selection.
4. Select the setting (line with a parameter number) with keys
EDIT
and press
5. Specify a new value for the setting with keys
Pressing the key once increments or decrements the value. Holding the key
down changes the value faster. Pressing the keys simultaneously replaces the
displayed value with the default value.
6. • To save the new value, press
• To cancel the new value and keep the original, press
Control panels
REF2 SELECT to AI1.
MENU
if you are in the Output mode, otherwise
repeatedly until you get to the Main menu.
ENTER
, and pressing .
.
SAVE
.
1103 REF1 SELECT has value AI1, you can
and , and
and
and .
CANCEL
.
Display
LOC MAIN MENU
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT 00:00
LOC I/O SETTINGS
DIGITAL INPUTS (DI)
ANALOG INPUTS
RELAY OUTPUTS
ANALOG OUTPUTS (AOUT)
PANEL
EXIT 00:00
LOC SHOW I/O
—DI1—
1001:START/STOP (E1)
—DI2—
—DI3—
EXIT 00:00
, LOC PAR EDIT
1001 EXT1 COMMANDS
DI1
[1]
CANCEL 00:00
LOC PAR EDIT
1001 EXT1 COMMANDS
DI1,2
[2]
CANCEL 00:00
LOC SHOW I/O
—DI1—
1001:START/STOP (E1)
—DI2—
1001:DIR (E1)
—DI3—
EXIT 00:00
1
ENTER
1
(AI)
(ROUT)
SEL
1
SAVE
SAVE
1