ABB ACS350 User Manual page 281

CODE FAULT
0028 SERIAL 1 ERR
(7510)
0306 bit 11
(programmable fault
function 3018, 3019)
0030 FORCE TRIP
(FF90)
0306 bit 13
0034 MOTOR PHASE
(FF56)
0306 bit 14
0035 OUTP WIRING
(FF95)
0306 bit 15
(programmable fault
function 3023)
0036 INCOMPATIBLE SW
(630F)
0307 bit 3
0101 SERF CORRUPT
(FF55)
0307 bit 14
0103 SERF MACRO
(FF55)
0307 bit 14
0201 DSP T1 OVERLOAD
(6100)
0307 bit 13
0202 DSP T2 OVERLOAD
(6100)
0307 bit 13
0203 DSP T3 OVERLOAD
(6100)
0307 bit 13
0204 DSP STACK ERROR
(6100)
0307 bit 12
0206 MMIO ID ERROR
(5000)
0307 bit 11
CAUSE
Fieldbus communication break
Trip command received from
fieldbus
Motor circuit fault due to
missing motor phase or motor
thermistor relay (used in motor
temperature measurement)
fault.
Incorrect input power and motor
cable connection (i.e. input
power cable is connected to
drive motor connection).
Loaded software is not
compatible.
Drive internal error
WHAT TO DO
Check status of fieldbus communication. See chapter
Fieldbus control with fieldbus adapter/Fieldbus
control with embedded fieldbus
fieldbus adapter manual.
Check fault function parameter settings.
Check connections.
Check if master can communicate.
See appropriate communication module manual.
Check motor and motor cable.
Check motor thermistor relay (if used).
Check input power connections.
Check fault function parameters.
Contact your local ABB representative.
Write down fault code and contact your local ABB
representative.
281
or appropriate
Fault tracing