Program Features; What This Chapter Contains; Start-Up Assistant; Introduction - ABB ACS350 User Manual

Program features

What this chapter contains

The chapter describes program features. For each feature, there is a list of related
user settings, actual signals, and fault and alarm messages.

Start-up Assistant

Introduction

The Start-up Assistant (requires the Assistant Control Panel) guides the user
through the start-up procedure, helping to enter the requested data (parameter
values) to the drive. The Start-up Assistant also checks that the entered values are
valid, i.e. within the allowed range.
The Start-up Assistant calls other assistants, each of which guides the user through
the task of specifying a related parameter set. At the first start, the drive suggests
entering the first task, Language Select, automatically. The user may activate the
tasks either one after the other as the Start-up Assistant suggests, or independently.
The user may also adjust the drive parameters in the conventional way without using
the assistant at all.
See section
other assistants.

The default order of the tasks

Depending on the selection made in the Application task (parameter
MACRO), the Start-up Assistant decides which consequent tasks it suggests. The
default tasks are shown in the table below.
Application Default tasks
selection
ABB STANDARD Language Select, Motor Set-up, Application, Option Modules, Speed Control EXT1, Speed Control
EXT2, Start/Stop Control, Timed Functions, Protections, Output Signals
3-WIRE Language Select, Motor Set-up, Application, Option Modules, Speed Control EXT1, Speed Control
EXT2, Start/Stop Control, Timed Functions, Protections, Output Signals
ALTERNATE Language Select, Motor Set-up, Application, Option Modules, Speed Control EXT1, Speed Control
EXT2, Start/Stop Control, Timed Functions, Protections, Output Signals
MOTOR POT Language Select, Motor Set-up, Application, Option Modules, Speed Control EXT1, Speed Control
EXT2, Start/Stop Control, Timed Functions, Protections, Output Signals
HAND/AUTO Language Select, Motor Set-up, Application, Option Modules, Speed Control EXT1, Speed Control
EXT2, Start/Stop Control, Timed Functions, Protections, Output Signals
PID CONTROL Language Select, Motor Set-up, Application, Option Modules, PID Control, Speed Control EXT2,
Start/Stop Control, Timed Functions, Protections, Output Signals
TORQUE CTRL Language Select, Motor Set-up, Application, Option Modules, Speed Control EXT2, Start/Stop
Control, Timed Functions, Protections, Output Signals
Assistants mode on page 76 on how to start the Start-up Assistant or
95
9902 APPLIC
Program features