ABB ACS350 User Manual page 50

50
Set the deceleration time 1 (parameter 2203).
Note: Set also deceleration time 2 (parameter 2206) if two
deceleration times will be used in the application.
The start-up is now completed. However, it might be useful at
this stage to set the parameters required by your application
and save the settings as a user macro as instructed in section
User macros
Check that the drive state is OK.
Basic Control Panel: Check that there are no faults or alarms
shown on the display. If you want to check the LEDs on the
front of the drive, switch first to remote control (otherwise a
fault is generated) before removing the panel and verifying that
the red LED is not lit and the green LED is lit but not blinking.
Assistant Control Panel: Check that there are no faults or
alarms shown on the display and that the panel LED is green
and does not blink.
Start-up, control with I/O and ID Run
SAVING A USER MACRO AND FINAL CHECK
on page 94.
The drive is now ready for use.
2203
LOC
PAR FWD
9902
LOC
PAR FWD