Copy Mode - ABB ACS350 User Manual

Copy mode

The Basic Control Panel can store a full set of drive parameters and up to three user
sets of drive parameters to the control panel. The control panel memory is non-
volatile.
In the Copy mode, you can do the following:
• Copy all parameters from the drive to the control panel (uL – Upload). This
includes all defined user sets of parameters and internal (not adjustable by the
user) parameters such as those created by the ID Run.
• Restore the full parameter set from the control panel to the drive (dL A –
Download All). This writes all parameters, including the internal non-user-
adjustable motor parameters, to the drive. It does not include the user sets of
parameters.
Note: Only use this function to restore a drive, or to transfer parameters to
systems that are identical to the original system.
• Copy a partial parameter set from the control panel to a drive (dL P – Download
Partial). The partial set does not include user sets, internal motor parameters,
parameters 9905...9909, 1605, 1607, 5201, nor any group
MODULE and
The source and target drives and their motor sizes do not need to be the same.
• Copy USER S1 parameters from the control panel to the drive (dL u1 – Download
User Set 1). A user set includes group
internal motor parameters.
The function is only shown on the menu when User Set 1 has been first saved
using parameter
and then uploaded to panel.
• Copy USER S2 parameters from the control panel to the drive (dL u2 – Download
User Set 2). As dL u1 – Download User Set 1 above.
• Copy USER S3 parameters from the control panel to the drive (dL u3 – Download
User Set 3). As dL u1 – Download User Set 1 above.
• Start, stop, change the direction and switch between local and remote control.
53 EFB PROTOCOL
9902 APPLIC MACRO (see section
parameters.
99 START-UP DATA
User macros
65
51 EXT COMM
parameters and the
on page 94)
Control panels