ABB ACS350 User Manual page 182

182
Parameters – complete descriptions
Index Name/Selection
DI2
DI3
DI4
DI5
COMM
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)
2015 MIN TORQUE 1
-600.0...0.0%
2016 MIN TORQUE 2
-600.0...0.0%
2017 MAX TORQUE 1
0.0...600.0%
2018 MAX TORQUE 2
0.0...600.0%
2019 BRAKE CHOPPER
2020 BRAKE CHOPPER
INBUILT
EXTERNAL
Actual signals and parameters
Description
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
Fieldbus interface as the source for the torque limit 1/2 selection, i.e. control
word 0301 FB CMD WORD 1 bit 15. The control word is sent by the fieldbus
controller via the fieldbus adapter or embedded fieldbus (modbus) to the
drive. For the control word bits, see section
page 262.
Maximum torque limit 1 is defined by parameter
maximum torque limit 2 is defined by parameter
Note: This setting applies only for the DCU profile!
Inverted digital input DI1. 1 = parameter
0 = parameter 2018 MAX TORQUE 2 value.
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
Defines minimum torque limit 1 for the drive. See parameter
TORQUE SEL.
Value in percent of the motor nominal torque
Defines minimum torque limit 2 for the drive. See parameter
TORQUE SEL.
Value in percent of the motor nominal torque
Defines maximum torque limit 1 for the drive. See parameter
TORQUE SEL.
Value in percent of the motor nominal torque
Defines maximum torque limit 2 for the drive. See parameter
TORQUE SEL.
Value in percent of the motor nominal torque
Old parameter. Left out in sw version 2.51b and later. See parameter 2202.
Selects the brake chopper control. (Only in sw version 2.51b or later).
Internal brake chopper control.
Note: Ensure the brake resistor(s) is installed and the overvoltage control is
switched off by setting parameter
DISABLE.
External brake chopper control.
Note: The drive is compatible only with ABB ACS-BRK-X brake units.
Note: Ensure the brake unit is installed and the overvoltage control is
switched off by setting parameter
DISABLE.
DCU communication profile
2017 MAX TORQUE 1 and
2018 MAX TORQUE 2.
2017 MAX TORQUE 1 value.
2005 OVERVOLT CTRL to selection
2005 OVERVOLT CTRL to selection
Def, FbEq
2
3
4
5
7
on
-1
-2
-3
-4
-5
2013 MIN -300
1 = 0.1%
2013 MIN -300
1 = 0.1%
2014 MAX 300
1 = 0.1%
2014 MAX 300
1 = 0.1%
INBUILT
0
1