Drive Control Parameters - ABB ACS350 User Manual

Drive control parameters

After the fieldbus communication has been set up, the drive control parameters
listed in the table below should be checked and adjusted where necessary.
The Setting for fieldbus control column gives the value to use when the fieldbus
interface is the desired source or destination for that particular signal. The Function/
Information column gives a description of the parameter.
Parameter
CONTROL COMMAND SOURCE SELECTION
1001 EXT1 COMMANDS
1002 EXT2 COMMANDS
1003 DIRECTION
1010 JOGGING SEL
1102 EXT1/EXT2 SEL
1103 REF1 SELECT
1106 REF2 SELECT
OUTPUT SIGNAL SOURCE SELECTION
1401 RELAY OUTPUT 1
1501 AO1 CONTENT
SEL
SYSTEM CONTROL INPUTS
1601 RUN ENABLE
1604 FAULT RESET SEL
1606 LOCAL LOCK
1607 PARAM SAVE
1608 START ENABLE 1
1609 START ENABLE 2
LIMITS
2013 MIN TORQUE SEL
2014 MAX TORQUE SEL
2201 ACC/DEC 1/2 SEL
2209 RAMP INPUT 0
Setting for Function/Information
fieldbus control
COMM Selects fieldbus as the source for the start and stop commands when
EXT1 is selected as the active control location.
COMM Selects fieldbus as the source for the start and stop commands when
EXT2 is selected as the active control location.
FORWARD Enables rotation direction control as defined by parameters 1001 and
REVERSE 1002. The direction control is explained in section
REQUEST handling. on page 254.
COMM Enables jogging 1 or 2 activation through fieldbus.
COMM Enables EXT1/EXT2 selection through fieldbus.
COMM Fieldbus reference REF1 is used when EXT1 is selected as the active
control location. See section
COMM+AI1
DCU profile) on page 249.
COMM*AI1
COMM Fieldbus reference REF2 is used when EXT2 is selected as the active
control location. See section
COMM+AI1
DCU profile) on page 249.
COMM*AI1
COMM Enables relay output RO control by signal
COMM(-1)
135 (i.e 0135 Directs the contents of fieldbus reference
COMM VALUE 1) analog output AO.
COMM Selects fieldbus interface as the source for the inverted Run Enable
signal (Run Disable).
COMM Selects fieldbus interface as the source for the fault reset signal.
COMM Selects fieldbus interface as the source for the local lock signal.
DONE; SAVE Saves parameter value changes (including those made through
fieldbus control) to permanent memory.
COMM Selects fieldbus interface as the source for the inverted Start Enable 1
(Start Disable) signal.
COMM Selects fieldbus interface as the source for the inverted Start Enable 2
(Start Disable) signal.
COMM Selects fieldbus interface as the source for the minimum torque limit
1/2 selection.
COMM Selects fieldbus interface as the source for the maximum torque limit
1/2 selection.
COMM Selects fieldbus interface as the source for acceleration/deceleration
ramp pair 1/2 selection
COMM Selects fieldbus interface as the source for forcing ramp input to zero.
Reference
Reference selection and correction
Reference selection and correction
0134 COMM RO WORD.
0135 COMM VALUE 1 to
Fieldbus control with fieldbus adapter
269
(for
(for