ABB ACS350 User Manual page 277

ALARM CODE CAUSE
5029 Memory is not ready.
5030 Invalid request
5031 Drive is not ready for operation, e.g due to low DC
voltage.
5032 Parameter error
5040 Parameter download error. Selected parameter set
is not in current parameter backup file.
5041 Parameter backup file does not fit into memory.
5042 Parameter download error. Selected parameter set
is not in current parameter backup file.
5043 No start inhibit
5044 Parameter backup file restoring error
5050 Parameter upload aborted
5051 File error
5052 Parameter upload has failed.
5060 Parameter download aborted
5062 Parameter download has failed.
5070 Panel backup memory write error
5071 Panel backup memory read error
5080 Operation is not allowed because drive is not in
local control mode.
5081 Operation is not allowed because of active fault.
5082 Operation is not allowed because override mode is
enabled.
5083 Operation is not allowed because parameter lock is
on.
5084 Operation is not allowed because drive is
performing task.
5085 Parameter download from source to destination
drive has failed.
5086 Parameter download from source to destination
drive has failed.
5087 Parameter download from source to destination
drive has failed because parameter sets are
incompatible.
5088 Operation has failed because of drive memory
error.
5089 Download has failed because of CRC error.
5090 Download has failed because of data processing
error.
5091 Operation has failed because of parameter error.
5092 Parameter download from source to destination
drive has failed because parameter sets are
incompatible.
WHAT TO DO
Retry.
Contact your local ABB representative.
Check input power supply.
Contact your local ABB representative.
Perform upload function before download.
Contact your local ABB representative.
Perform upload function before download.
Check that file is compatible with drive.
Retry parameter upload.
Contact your local ABB representative.
Retry parameter upload.
Retry parameter download.
Retry parameter download.
Contact your local ABB representative.
Contact your local ABB representative.
Switch to local control mode.
Check cause of fault and reset fault.
Check parameter 1602 PARAMETER LOCK
setting.
Wait until task is completed and retry.
Check that source and destination drive types
are same, i.e. ACS350. See drive type
designation label.
Check that source and destination drive type
codes are same. See drive type designation
label.
Check that source and destination drive
information are same. See parameters in group
33 INFORMATION.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Check that source and destination drive
information are same. See parameters in group
33 INFORMATION.
277
Fault tracing