X5343: Remc L Carrier Length Setup Register (Remc_Carl) - Epson S1C17001 Technical Manual

21 REMOTE CONTROLLER (REMC)

0x5343: REMC L Carrier Length Setup Register (REMC_CARL)

Register name Address Bit
REMC L Carrier 0x5343 D7–6 –
Length Setup (8 bits)
D5–0 REMCL[5:0] L carrier length setup
Register
(REMC_CARL)
D[7:6] Reserved
D[5:0] REMCL[5:0]: L Carrier Length Setup Bits
Set the carrier signal L section length. (Default: 0x0)
Specify a value corresponding to the number of carrier generation clock cycles selected by CG-
CLK[3:0] (D[7:4]/REMC_PSC register) + 1.
Calculate carrier L section length as follows:
Carrier L section length = —————— [s]
REMCH: REMCL[5:0] settings
clk_in:
The H section length is specified by REMCH[5:0] (D[5:0]/REMC_CARH register).
The carrier signal is generated from these settings as shown in Figure 21.7.1.
282
Name Function
reserved
REMCL + 1
clk_in
Prescaler output clock frequency
Setting
–
0x0 to 0x3f
EPSON
Init. R/W Remarks
– – 0 when being read.
0x0 R/W
S1C17001 TECHNICAL MANUAL