Multiple Mountings - Epson E2C Series Manipulator Manual

3.5.2 Multiple Mountings

■ Install the Multiple Mounting Manipulator with two or more people.
The Manipulator weighs approximately 16 kg. Be careful not to get hands,
fingers, or feet caught and/or have equipment damage by the fall of the
Manipulator.
■ When mounting the Manipulator on the wall, do not remove the support until all
WARNING
the anchor bolts are secured. Removing the support while the anchor bolts are
not secured sufficiently is extremely hazardous and may result in fall of the
Manipulator.
The Multiple Mountings Manipulators have mounting holes available for the following
installation patterns.
NOTE Design and make the base table for anchoring the Multiple Mounting Manipulators so that
it does not touch any cable connected to the base connector plate.
The recommended installation patterns are as follows:
E2C Rev.6
Setup & Operation 3. Environments and Installation
Side
Top Shelf
Side
Ceiling
Bottom Shelf
Ceiling
31