Relocation And Storage; Precautions For Relocation And Storage - Epson E2C Series Manipulator Manual

Setup & Operation 3. Environments and Installation

3.8 Relocation and Storage

3.8.1 Precautions for Relocation and Storage

Observe the following when relocating, storing, and transporting the Manipulators.
THE INSTALLATION SHALL BE MADE BY QUALIFIED INSTALLATION
PERSONNEL AND SHOULD CONFORM TO ALL NATIONAL AND LOCAL
CODES.
■ Before relocating the Manipulator, fold the arm and secure it tightly with a wire tie
to prevent hands or fingers from being caught in the Manipulator.
■ When removing the anchor bolts, support the Manipulator to prevent falling.
Removing the anchor bolts without supporting may result in fall of the
Manipulator, and then get hands, fingers, or feet caught.
■ To carry the Manipulator, have two or more people to work on it and secure the
Manipulator to the delivery equipment or hold the bottom of Arm #1, bottom of the
CAUTION
main cable fitting, and bottom of the base by hand. When holding the bottom of
the base by hand, be very careful not to get hands or fingers caught.
Do not hold the duct joint on the back of the base.
■ Stabilize the Manipulator with your hands when hoisting it. Unstable hoisting is
extremely hazardous and may result in fall of the Manipulator.
When transporting the Manipulator for a long distance, secure it to the delivery
equipment so that the Manipulator cannot fall.
If necessary, pack the Manipulator in the same way as it was delivered.
When the Manipulator is used for robot system again after long-term storage,
perform a test run of it to verify that it works properly, and then operate it
thoroughly.
Transport and store the Manipulator in the range of -25°C to +55°C.
Humidity within 10% to 90% is recommended.
When condensation occurs on the Manipulator during transport or storage, turn
ON the power only after the condensation dries.
Do not shock or shake the Manipulator during transport.
38 E2C Rev.6