Greasing And Replacing The Ball Screw Spline Unit - Epson E2C Series Manipulator Manual

10. Greasing and Replacing the Ball Screw Spline Unit

■ Do not insert or pull out the motor connectors while the power to the robot system
is turned ON. Inserting or pulling out the motor connectors with the power ON is
extremely hazardous and may result in serious bodily injury as the Manipulator
may move abnormally, and also may result in electric shock and/or malfunction of
the robot system.
■ To shut off power to the robot system, pull out the power plug from the power
source. Be sure to connect the AC power cable to a power receptacle. DO
NOT connect it directly to a factory power source.
WARNING
■ Before performing any replacement procedure, turn OFF the controller and
related equipment, and then pull out the power plug from the power source.
Performing any replacement procedure with the power ON is extremely
hazardous and may result in electric shock and/or malfunction of the robot
system.
After parts have been replaced (motors, reduction gear units, a brake, timing belts, a ball
NOTE
screw spline unit, etc.), the Manipulator cannot operate properly because a mismatch
exists between the origin stored in each motor and its corresponding origin stored in the
Controller.
After replacing the parts, it is necessary to match these origins.
The process of aligning the two origins is called "Calibration".
Refer to Maintenance: 14. Calibration and follow the steps that pertain to the software
you are using to perform the calibration.
E2C Rev.6
Maintenance 10. Greasing and Replacing the Ball Screw Spline Unit
165