Table of Contents
Advertisement
Operating Procedure (cont'd)
4.
Deleting Stored Number (for the D
a.) Display the desired number by pressing the Call Return key. (refer to (2b).)
b.) Press the "#" or "*" key (determined by System Data). The displayed number is deleted
and "CNCL" is displayed on the D
Note 1: When all the stored numbers are deleted, the Call Return key goes off.
Note 2: Note that the delete key ("#" or "*") is effective while the calling number is displayed [5 seconds].)
Manual saving (equal to SAVE AND REPEAT - D
1.
Saving a Calling Number
a.) Press the S&R key while in conversation using My Line or Sub Line.
b.) The received calling number is saved and the S&R key lights red.
Note:
One calling number can be saved. When a calling number has already saved using SAVE AND REPEAT -
term
D
, the calling number is deleted.
2.
Call Origination
a.) Lift the handset and receive Dial Tone.
b.) Press the S&R key. The stored number is dialed.
Note:
The dialed number is automatically deleted and the S&R key goes off.
Service Conditions
Automatic/Manual Saving
1.
This feature is available for Series 6300 software or later.
2.
This feature is not available when the calling number is not received. For receiving the calling
number (Caller ID) via an analog trunk, the following circuit cards are required:
Circuit Card Name
PA-8COTBJ
3.
Automatic/Manual Saving is available for the D
card:
Circuit Card Name
PA-16ELCJ
PA-DAIG (2M-AMI)
PA-DAIJ (1.5M-AMI)
PA-DAIH
PA-2DAIK (2M-AMI)
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Call Return
term
with the CALL RETURN key)
term
LCD.
term
[S-24D])
Firmware
SW-317 8COTBJ PROG-A
SP-1122 CALL-ID PROG-A
SP-3190 8COTBJ PROG-A
term
Firmware
SP-3270 (ISSUE 3 or later)
SW-362 2WDAI PROGRAM-F
SP-3305 2WDAI PROGRAM-F
SM-196 PAD DATA-A
SM-197 PBSD DATA-A
SW-361 2WDAI PROGRAM-F
SP-3305 2WDAI PROGRAM-F
SM-196 PAD DATA-A
SM-197 PBSD DATA-A
s assigned to the following ELC/DAI circuit
C-151
Remarks
Remarks
Page 187
Advertisement
Table of Contents
