Table of Contents
Advertisement
P-2
P-2
General Description
This feature allows the Attendant to PASS DIAL TONE to a restricted station user, enabling that user to
place a call that would normally be restricted.
Operating Procedure
To operate:
1.
Restricted station user dials Attendant.
2.
Attendant presses "ANSWER" or "ATND" key; tenant number, trunk route restriction class and
station number are displayed.
3.
Obtain call details.
4.
Dial central office access code; tenant number, and trunk identification number are displayed.
5.
Press "RELEASE" key; station user hears Dial Tone.
6.
Station user places the call.
Service Conditions
1.
This feature permits PASSING DIAL TONE to restricted and unrestricted stations only by the
Attendant.
2.
When LEAST COST ROUTING - 3/6-DIGIT [L-5] is provided in the system, the Attendant cannot
pass Dial Tone. The call must be completed via the ATTENDANT CONSOLE [A-3].
3.
TOLL RESTRICTION [T-7] is activated via system programming for the PASSING DIAL TONE
feature.
4.
The PASSING DIAL TONE feature is limited by the number of trunks that can be accessed by
the Attendant and the Class of Service restrictions of the station.
5.
Restriction from Outgoing Calls: This feature can be overridden by the use of the PASSING DIAL
TONE feature.
6.
The Attendant is allowed to pass Dial Tone to any station that has a class of service that allows
normal direct dial access capabilities to the trunk group seized by the Attendant.
7.
Any non-restricted station can dial through over the selected outgoing trunk. The type of address
signals sent to the called location are determined by the trunk route class data.
8.
Where SMDR [S-10] is provided, through-dialed calls are charged to the calling station line.
9.
This feature is available when the numbering plan for call origination is Outgoing Call (OGC) or
Outgoing Call Alternative (OGCA), and the answer-back signal is the Second Dial Tone (Mark-
out method).
10. When placing outside calls, activation of the TOLL RESTRICTION - 3/6-DIGIT [T-7] is
determined by System Data of the calling station on a tenant basis.
11. If TOLL RESTRICTION- 3/6-DIGIT [T-7] is not activated via System Data, neither the 3-digit area
code nor the 6-digit area and office code are restricted.
12. If TOLL RESTRICTION- 3/6-DIGIT [T-7] is activated via System Data, the call will be restricted
when the calling party dials the restricted area code.
Page 402
Passing Dial Tone
Passing Dial Tone
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Advertisement
Table of Contents
