Table of Contents
Advertisement
R-16
Service Conditions (cont'd)
5.
A station that has the CALL HOLD [C-6] feature activated cannot use RADIO PAGING.
6.
The maximum number of RADIO PAGING answer zones is six.
7.
The maximum number of routes that can be assigned RADIO PAGING is six.
8.
If the paging station user has failed to hang up within a predetermined, programmable time
interval (after activation), the paging connection is forcibly released.
9.
If the paged party does not answer within 30 seconds, the NEAX2400 ICS will automatically
page that party again. If the paged party does not answer the second page within 30 seconds,
the paging request will be cancelled from memory. (See VARIABLE TIMING PARAMETERS
1]).
10. Both the COT card and the TLT card can be used as the paging trunk.
11. Loop signaling is the recommended signaling type.
Interactions
1.
If the range of the radio page transmitter exceeds the physical limits of the PBX, an incoming
C.O. call acting as a response to a Radio Page cannot be connected in loop-to-loop procedures.
The paging party must disconnect, and the Attendant must extend the paged party's C. O. call.
2.
RADIO PAGING and PAGING ACCESS [P-1] can be provided simultaneously in the same
system. Separate access codes for each feature are required. A RADIO PAGING answer code
is required for each Radio Paging zone.
3.
RADIO PAGING is limited to stations and Attendant Consoles. Other parties (C.O./TIE trunk
calls) must have the Attendant or station user perform the paging operation.
4.
The Attendant cannot dial the RADIO PAGING answer codes.
5.
BUSY VERIFICATION [B-3], EXECUTIVE OVERRIDE [E-1]: These features will be denied
when connected to the Radio Paging route.
6.
Radio Page Answer will not follow any hunting on forwarding that the paging station has set.
Page 440
Radio Paging
NEAX2400 ICS Business Features and Specifications
[V-
NDA-24143, Issue 4
Advertisement
Table of Contents
