Table of Contents
Advertisement
A-29
Interactions (cont'd)
Note:
The access code to the feature AUTHORIZATION CODE - TIE LINE INCOMING ROUTES must be
assigned within the PBX numbering plan.
6.
If ASPA, SRV = LCR (Least Cost Route Selection) / LCRS (Register Sender LCR) AH parameter
is assigned as data "1", the request for an AUTHORIZATION CODE is determined by the ARSC
assignment of the station in relationship to the route chosen. For AUTHORIZATION CODE - TIE
LINE INCOMING ROUTES, no RSC is assigned against the incoming TIE Line, therefore,
AUTHORIZATION CODEs are always required. Trunk connection will be determined against the
RSC of the dialed code.
term
7.
When a D
AUTHORIZATION CODE will be recorded if previously dialed.
8.
The AMND command determines the length of AUTHORIZATION CODEs based on the first digit
of the code.
9.
AUTHORIZATION CODEs are recorded by STATION MESSAGE DETAIL RECORDING [S-10].
10. AUTHORIZATION CODEs cannot be entered by the Attendant Console.
11. PEG COUNTS [P-7] of invalid AUTHORIZATION CODEs are not available.
12. AUTHORIZATION CODEs can be dialed by a station user, when establishing a
CONSULTATION HOLD [C-17] connection.
13. For Procedure 2, LCR(S) must be provided.
14. For senderized TIE Lines, see UNIVERSAL SENDER [U-3]. Also, the ANND command must be
programmed for senderized TIE Lines. If other services, such as, STATION MESSAGE DETAIL
RECORDING [S-10] and LEAST-COST ROUTING [L-5], the AMND command will be
programmed. If digit translation is required, go to the ASTP and AOSP command.
15. MISCELLANEOUS TRUNK RESTRICTION [M-3]. Restrictions to TIE trunks are determined by
the Route Service Class (RSC) assigned to the AUTHORIZATION CODE.
Page 32
Authorization Code - Tie Line Incoming Routes
user initiates the LAST NUMBER CALLED - D
term
[L-6D] feature, the
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Advertisement
Table of Contents
