Table of Contents
Advertisement
D-87
Service Conditions
term
1.
Only D
s can be assigned as a member of a DIAL INTERCOM group.
2.
All members of the same DIAL INTERCOM group must be assigned in the same Module Group.
3.
Up to 32 stations may be assigned to one DIAL INTERCOM group. Each station in the DIAL
INTERCOM group can be assigned as an Automatic, a Manual and a DIAL INTERCOM member
of three different groups.
4.
No more than one connection can be established at the same time in one DIAL INTERCOM
group.
5.
A three-party conference can be established in a DIAL INTERCOM group if Intercom Bridge
service is available. If a fourth party tries to activate Intercom Bridge service, the connection is
denied.
6.
The maximum number of DIAL INTERCOM groups in the PBX is 50 per Module Group.
7.
It is possible to simultaneously assign one group of stations as an Automatic/Manual Intercom
group, as well as a DIAL INTERCOM group.
8.
The distinctive ringing (three-burst ringing) sent from an incoming DIAL INTERCOM station
takes priority over the ringing of multi-line appearances.
9.
Features normally available to multi-line appearances are not available to DIAL INTERCOM
lines.
10. DIAL INTERCOM lines cannot be held by pressing the HLD key.
11. When a station is moved from one DIAL INTERCOM group to another via system commands,
the DICM key on the associated D
12. Port traffic and station PEG COUNTS [P-7] reports will record the use of the DIAL INTERCOM
feature under "other."
term
13. Dedicated D
key for hands-free operation can be used.
14. If there are simultaneous incoming calls to the Prime Line, Automatic Intercom Line, the Manual
Intercom Line, and/or the DIAL INTERCOM line, the Prime Line will normally be selected when
the station goes off-hook. The selection order can be changed for each D
assignment.
15. DIAL INTERCOM group numbers are either one or two digits and can be set for each DIAL
INTERCOM group.
1 digit: 0-9
2 digits: 00-63
Page 220
Dial Intercom
term
function keys cannot be used during a DIAL INTERCOM call. Only the SPKR
must be deleted before the change is made.
NEAX2400 ICS Business Features and Specifications
term
via office data
NDA-24143, Issue 4
Advertisement
Table of Contents
