Voice Call - NEC NEAX 2400 ICS Features Manual

V-2
V-2
General Description
This feature enables a single line telephone to make a VOICE CALL [V-2] when the called party is a D
set. This path exists from the calling party to the called party's built-in speaker. If the called party's MIC is
on, the called party can converse hands-free.
Operating Procedure
From a single line station to a D
1. Dial the desired D
2. Perform a switchhook flash.
3. Dial the VOICE CALL access code. A signal tone (two bursts) is transmitted over the called
party's speaker.
term
4. Called D
term
D Series E
5. Announce the call over the built-in speaker.
Service Conditions
1. When the called station is not a D
determined time, followed by Ringback Tone.
2. Once a VOICE CALL has been activated, the called station will appear busy on multi-line sets
displaying the called station.
3. VOICE CALL will follow CALL FORWARDING - ALL CALLS [C-5] and CALL FORWARDING -
BUSY/DON'T ANSWER [C-2, 3].
4. VOICE CALL will terminate at the station whose my line is the same as the extension called.
5. Only the called station can respond HANDS-FREE [H-5D].
6. STATION MESSAGE DETAIL RECORDING SYSTEM [S-10] is not available for this service.
Page 538
term
:
term
station number and receive Ringback Tone.
displays:
VDC

VOICE CALL

Voice Call
Voice Call
(Time Display)
(Time Display)
term
, Reorder Tone will be sent to the calling party for a pre-
NEAX2400 ICS Business Features and Specifications
XXXX
XXXX
NDA-24143, Issue 4
term