Table of Contents
Advertisement
A-20
Interactions (cont'd)
5.
There are no restrictions regarding the first digit of AUTHORIZATION CODES, except what is
programmed in AMND. Tenant 0 does not conflict with the PBX numbering plan. This is true
when separate tenant tables are provided. If common tenant tables are used, a conflict between
LCR(S) and OGC(A), used with SMDR, will occur.
Note:
The access code to the service feature AUTHORIZATION CODE must be assigned within the PBX
numbering plan.
6.
If ASPA, SRV = LCR (Least Cost Route Selection) / LCRS (Register Sender LCR) AH parameter
is assigned as data "1", the request for an AUTHORIZATION CODE is determined by the ARSC
assignment of the station in relationship to the chosen route.
7.
An AUTHORIZATION CODE can be entered when a MODEM POOLING [M-21] call is
established by a D
term
8.
When a D
CODE will be recorded if previously dialed.
9.
The AMND command determines the length of AUTHORIZATION CODES, based on the first
digit of the code.
10. AUTHORIZATION CODES are recorded by STATION MESSAGE DETAIL RECORDING [S-10],
Procedure 2.
11. AUTHORIZATION CODES cannot be entered by the Attendant Console.
12. PEG COUNTS [P-7] of invalid AUTHORIZATION CODES are not available.
13. AUTHORIZATION CODES can be dialed by a station user when establishing a
CONSULTATION HOLD [C-17] connection.
14. For Procedure 2, LCR(S) must be provided.
Page 28
Authorization Code
term
but not when accessed via a Data Module.
user initiates the LAST NUMBER DIALED [L-6D] feature, the AUTHORIZATION
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Advertisement
Table of Contents
