Table of Contents
Advertisement
S-3
General Description
This feature allows a station user or ATTENDANT CONSOLE [A-3] to call certain frequently dialed
numbers using fewer digits (abbreviated call codes) than would normally be required.
Operating Procedure
To operate:
1.
Lift handset; receive Dial Tone,
2.
(Series 6100 software enhancement) Dial SPEED CALLING - SYSTEM access code
(maximum three digits),
(Series 6100 software enhancement) Dial abbreviated call code (maximum four digits),
3.
4.
Call is completed.
Service Conditions
1.
SPEED CALLING - SYSTEM codes programmed into System Data are accessible by all stations
with a CLASS OF SERVICE - INDIVIDUAL [C-15] permitting SPEED CALLING - SYSTEM.
2.
Each abbreviated call code can store a maximum of 24 digits, including access codes and
pauses.
3.
A maximum of 1000 Speed Calling numbers can be stored in the system (000 ~ 999).
Note:
Capacity depends on system configuration because of memory capacity.
4.
SPEED CALLING - SYSTEM numbers are programmed via System Data entry from the
MAINTENANCE ADMINISTRATION TERMINAL (MAT) [M-18].
5.
Stations may be denied access to SPEED CALLING - SYSTEM via CLASS OF SERVICE [C-15]
assignment in System Data. SPEED CALLING may also be allowed or denied on either a station
or tenant-wide basis.
6.
TOLL DENIAL/TOLL DIVERSION [T-6] and TOLL RESTRICTION-3/6-DIGIT [T-7] may or may
not be applied to SPEED CALLING - SYSTEM, as desired.
7.
LEAST-COST ROUTING-3/6-DIGIT [L-5] may be provided via SPEED CALLING - SYSTEM
access.
8.
If the station is restricted from dialing outside via programming, the station can still access
SPEED CALLING - SYSTEM.
Interactions
1.
FORCED ACCOUNT CODES [F-7] and AUTHORIZATION CODES [A-20] cannot be
programmed for use via the SPEED CALLING-SYSTEM.
2.
Pauses are programmable from the MAT using the "P" key of the keyboard. Pauses consume
one digit of the available 24 digits. A pause lasts for 2.8 seconds. A pause cannot be added
directly after an LCR access code.
3.
TOLL DIVERSION/TOLL DENIAL [T-6] and TOLL RESTRICTION 3/6 DIGIT [T-7] will interact
with this feature if SPEED CALLING-SYSTEM is toll restricted.
4.
Special
Dial
AUTHORIZATION CODES [A-20] are operational in the system and Toll Restriction applies to
SPEED CALLING-SYSTEM.
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Speed Calling - System
Speed Calling - System
Tone
may be
returned after
dialing SPEED
CALLING-SYSTEM
S-3
if
Page 449
Advertisement
Table of Contents
