NEC NEAX 2400 ICS Features Manual page 495

Service Conditions (cont'd)
11. FORCED ACCOUNT CODE [F-7] can be recorded on SMDR, for INWATS and CO incoming
calls, when used in conjunction with the REMOTE ACCESS TO SYSTEM [R-2] service feature.
12. FORCED ACCOUNT CODE [F-7] cannot be registered on SMDR if the incoming REMOTE
ACCESS TO SYSTEM [R-2] calls are terminated to stations via night service or DID [D-8].
13. For REMOTE ACCESS TO SYSTEM [R-2] tandem connections, the FORCED ACCOUNT
CODE [F-7] is registered for outgoing trunks only.
14. The NEAX2400 ICS can accommodate up to 7 active ports or 4 redundant ports. Additional
hardware is required.
15. AUTHORIZATION CODE [A-20] can be recorded on SMDR.
16. The maximum number of simultaneous calls can be stored in the system memory (active calls)
is:
SIM (ICS) or IMGx
IMGxh or IMGdxh
MMG/UMG (ICS) or UMGx
When a call is completed, the record is sent to the output device and is removed from memory.
17. If an overflow (greater than 3,000 IMG (ICS)) or 20,000 (MMG/UMG (ICS) active calls) occurs,
calls are allowed to complete and are not recorded.
18. ATTENDANT-CONTROLLED CONFERENCE [A-2]: If the Attendant adds a trunk to the
conference, the Attendant conference line terminal is recorded.
19. LEAST COST ROUTING - 3/6-DIGIT [L-5]: The calling party can dial an ACCOUNT CODE [A-
18] before the LCR access code. The called number is recorded (as modified for sending).
20. If an ACCOUNT CODE [A-18] is dialed, the maximum digits of the called number is 22.
21. CENTRALIZED ATTENDANT SERVICE (CAS) [C-20]: The SMDR record is provided for calls
extended outward by a CAS Attendant.
22. DIRECT INWARD DIALING (DID) trunk calls [D-8]: If the call is to the Attendant, the Attendant
can input an ACCOUNT CODE [A-18] before extending the call.
23. INDIVIDUAL TRUNK ACCESS [I-4]: The Attendant cannot dial in an SMDR account code before
using direct trunk selection.
24. Incoming TIE trunk calls: If an incoming call to the Attendant is extended, the Attendant can input
an ACCOUNT CODE [A-18].
25. SERIAL CALL [S-15]: The duration of the total call is recorded on the last station call.
26. STATION HUNTING [S-7, 8, 9]: The hunted-to station is recorded in the called number field.
27. TANDEM TIE TRUNK [T-1] Calls: The calling number is the incoming trunk route plus trunk
number; the called number is the number dialed.
28. UNIFORM CALL DISTRIBUTION (UCD) [U-1]: The calling number is the incoming trunk route
plus trunk number. If the call is to a PBX station, the station answering the number is recorded
as the dialed number.
29. On an incoming trunk call to the Attendant, the Attendant call record will start upon answering
and complete when the Attendant releases. A station call record will start when the Attendant
releases and complete when the station goes on-hook. If required, a station record will not be
generated if the station does not answer.
30. A system option is available to allow or restrict call completion in the case where a failure occurs
in transmitting SMDR data from the processor to the I/O port.
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Station Message Detail Recording (SMDR)
3,000
10,000
10,000 (basic) or 40,000 (option)
S-10
Page 465