Table of Contents
Advertisement
Service Conditions (cont'd)
6.
Slave stations and their associated Master station must belong to the same Module Group.
7.
A slave can only be assigned to one Master group.
8.
TOLL DENIAL/TOLL DIVERSION [T-6] and TOLL RESTRICTION-3/6-DIGIT [T-7] may or may
not be applied to Speed Calling, as desired.
9.
LEAST-COST ROUTING-3/6-DIGIT [L-5] may be provided via Speed Calling access.
10. SPEED CALLING-GROUP and SPEED CALLING-STATION [S-21] use the same block of
memory tables.
11. SPEED CALLING-GROUP data remains, even if the system is reinitialized or there is a power
failure.
12. A pause may be programmed using the "
available. Rotary type phones cannot store a pause. A pause lasts 2.8 seconds.
13. Stations can be added or removed from a group only via MAINTENANCE ADMINISTRATION
TERMINALS (MAT) - [M-18].
14. When a caller places a call via Outgoing Call Alternative (OGCA), and when the first outgoing
route and the station setting SPEED CALLING - GROUP are restricted, this service cannot be
set. In this case, the service can be set via the following procedure:
a.) assign a dummy route
b.) clear the restriction between the dummy route and all the stations
c.) assign the dummy route as the first route of OGCA.
Interactions
1.
Blocks are not assigned sequentially (1-100), but are assigned as a quantity of blocks in the
AISA command. These quantities will never exceed the value of 10.
2.
If one block is assigned, the Abbreviated Call Code will be digits 0-9. If two blocks are assigned,
the Abbreviated Call Code will be digits 00-19. If three blocks are assigned, the Abbreviated Call
Code will be digits 00-29, and so on, to a maximum of 10 blocks with Abbreviated Call Codes
00-99.
3.
Only the Master station will be allowed access to the SPEED CALLING-ASSIGN access code.
4.
Only those stations assigned as Slave stations are considered to be members of the SPEED
CALLING-GROUP.
5.
Stations of a SPEED CALLING-GROUP must be in the same Module Group (MG).
6.
SPEED CALLING-GROUP requires the assignment of senders, route 905. See UNIVERSAL
SENDER [U-3].
7.
OUTGOING TRUNK QUEUING [O-2]: This feature may be used with SPEED CALLING GROUP
if all trunks are busy.
8.
ROUTE ADVANCE [R-6] and LEAST-COST ROUTING-3/6 DIGIT [L-5] may be used with this
feature. The ASPA access code to either ROUTE ADVANCE [R-6] or LEAST-COST ROUTING-
3/6 DIGIT [L-5] will be stored in the memory of the SPEED CALLING-GROUP number.
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Speed Calling - Group
*
" button of a PB pad. This will take one of the 24 digits
S-23
Page 477
Advertisement
Table of Contents
