Table of Contents
Advertisement
S-33
S-33
General Description
This feature permits ports that do not physically exist to be used as sub-lines on D
normally reserved on a D
APPEARANCE. Also, 64 software ports have been added to a Port Interface Module. The 64 software-
assigned ports can be assigned as virtual line appearances on D
and the 64 software-assigned ports conserve valuable hardware for stations and trunks.
Operating Procedure
Call Origination via a SOFTWARE-LINE APPEARANCE on a D
1.
Press the SOFTWARE LINE APPEARANCE key, then either press the spkr key or lift the
handset.
2.
Upon hearing Dial Tone, dial the desired number.
Calling a SOFTWARE LINE APPEARANCE from a station/trunk/Attendant Console:
1.
The calling party dials the station number of the SOFTWARE LINE APPEARANCE.
term
2.
Any D
accommodating the SOFTWARE LINE APPEARANCE will receive ringing and have
an incoming lamp display. The D
answer the incoming call.
Service Conditions
1.
When using a SOFTWARE LINE APPEARANCE assigned to a data port (TEC:12), call
origination from that line appearance can be made if the card is mounted in that slot.
2.
A mix of data ports and sub-lines can be assigned on a D
3.
All sub-lines of D
4.
A SOFTWARE LINE APPEARANCE cannot be assigned as a Hotline Station, but can be
assigned as a BROKERAGE HOTLINE [B-12] station.
5.
A SOFTWARE LINE APPEARANCE cannot activate:
CALL BACK
OUTGOING TRUNK QUEUING
NAILED-DOWN CONNECTION
6.
When activating CALL PICKUP-GROUP [C-7], the sub-line will pick up calls assigned to the
CALL PICKUP-GROUP of the MY-Line of the D
7.
When accessing or entering SPEED CALLING [S-2] group/station data, a SOFTWARE LINE
APPEARANCE will enter or access the SPEED CALLING [S-2] group/station data of the MY-
Line of the D
8.
The STATION MESSAGE DETAIL RECORDING (SMDR) RS232C [S-10] of the SOFTWARE
LINE APPEARANCE call activity will be recorded as the MY-Line call activity.
9.
The SOFTWARE LINE APPEARANCE cannot be the called station of the following features:
VOICE CALL
MESSAGE REMINDER
BOSS-SECRETARY OVERRIDE
10. Station PEG COUNT [P-7] data will be recorded for SOFTWARE LINE APPEARANCEs as a
MY-Line of the D
Page 484
Software Line Appearance
Software Line Appearance
term
for data stations only, can be assigned as a SOFTWARE LINE
term
term
s must be located in the same Local Processor as the MY-Line of that D
term
on which the sub-line appears.
term
.
term
term
:
station user presses the LINE key and goes off-hook to
term
[C-1]
[O-2]
[N-9]
term
on which the sub-line appears.
[V-2D]
[M-22D]
[B-5]
NEAX2400 ICS Business Features and Specifications
term
stations. Ports
stations. The use of the data ports
package.
NDA-24143, Issue 4
term
.
Advertisement
Table of Contents
