Mitsubishi Electric Q26UD(E)HCPU User Manual page 163

Item
Program memory
Memory card (RAM)
Max. number
Memory card
of files stored
(ROM)
Standard RAM
Standard ROM
Max. number of intelligent
function module parameters
No. of times of writing data into the program
memory
No. of times of writing data into the standard
ROM
No. of I/O device points
(No. of points usable on program.)
No. of I/O points
(No. of points accessible to the actual I/O
module.)
*6
Internal relay [M]
*6
Latch relay [L]
*6
Link relay [B]
*6
Timer [T]
*6
Retentive timer [ST]
*6
Counter [C]
*6
Data register [D]
Extended data register [D]
*6
Link register [W]
Extended link register [W]
*6
Annunciator [F]
*6
Edge relay [V]
*6
Link special relay [SB]
*6
Link special register [SW]
Q00UJCPU
Flash card
ATA card
----
Initial
setting
Refresh
256 points
(X/Y0 to FF)
The low- and high-speed timers are specified by the instructions.
The measurement unit of the low- and high-speed timers is set up by parameters.
(Low-speed timer: 1 to 1000ms, 1ms unit, 100ms by default)
(High-speed timer: 0.01 to 100ms, 0.01ms unit, 10.00ms by default)
0 points by default (sharing of the low- and high-speed retentive timers) (changeable)
The low- and high-speed retentive timers are specified by the instructions.
The measurement unit of the low- and high-speed retentive timers is set up by
(Low-speed retentive timer: 1 to 1000ms, 1ms unit, 100ms by default)
(High-speed retentive timer: 0.01 to 100ms, 0.01ms unit, 10.00ms by default)
Normal counter, 1024 points by default (C0 to 1023) (changeable)
----
----
Universal model QCPU
Q00UCPU Q01UCPU
*7
32
----
----
----
4 files (each one of the following files: file register file, local device
file, sampling trace file, and module error collection file)
128
512
256
Max. 100000 times
Max. 100000 times
8192 points (X/Y0 to 1FFF)
1024 points
(X/Y0 to 3FF)
8192 points by default (M0 to 8191) (changeable)
8192 points by default (L0 to 8191) (changeable)
8192 points by default (B0 to 1FFF) (changeable)
2048 points by default (T0 to 2047) (changeable)
(Sharing of low- and high-speed timers)
parameters.
12288 points by default (D0 to 12287) (changeable)
0 points by default (changeable)
8192 points by default (W0 to 1FFF) (changeable)
0 points by default (changeable)
2048 points by default (F0 to 2047) (changeable)
2048 points by default (V0 to 2047) (changeable)
2048 points by default (SB0 to 7FF) (changeable)
2048 points by default (SW0 to 7FF) (changeable)
CHAPTER 6 CPU MODULE
Q02UCPU
*7
64
319 (When the
Q3MEM-8MBS is
used)
288
511
2048
1024
*4
*5
2048 points
(X/Y0 to 7FF)
161
6