Mitsubishi Electric Q26UD(E)HCPU User Manual page 352

Error
Error and cause
code
[ICM. OPE. ERROR]
• The memory card or SD memory card has not
been formatted.
• The formatting status of the memory card or SD
memory card is incorrect.
■Collateral information
• Common information: Drive Name
• Individual information: -
■Diagnostic timing
• When memory card is inserted or removed
[ICM. OPE. ERROR]
• Formatting an SD memory card is failed.
• SD memory card failure is detected.
2301
■Collateral information
• Common information: Drive Name
• Individual information: -
■Diagnostic timing
• When memory card is inserted or removed
[ICM. OPE. ERROR]
The QCPU file does not exist in the Flash card.
■Collateral information
• Common information: Drive Name
• Individual information: -
■Diagnostic timing
• When memory card is inserted or removed
[ICM. OPE. ERROR]
• SRAM card failure is detected. (It occurs when
automatic format is not set.)
• Writing parameters was performed during
setting file registers.
■Collateral information
• Common information: Drive Name
• Individual information: -
■Diagnostic timing
• When memory card is inserted or
removed/When writing to the memory card
[ICM. OPE. ERROR]
A memory card or SD memory card that cannot be
used with a CPU module has been inserted.
■Collateral information
2302
• Common information: Drive Name
• Individual information: -
■Diagnostic timing
• When memory card is inserted or removed
[CASSETTE ERROR]
An extended SRAM cassette is inserted or
removed while the CPU module is powered on.
■Collateral information
2350
• Common information: -
• Individual information: -
■Diagnostic timing
• Always
350
Corrective action
• Format the memory card or SD memory
card.
• Reformat the memory card or SD memory
card.
If the memory card is a flash card, write data
to the flash card in any of the following
methods.
1) Write program memory to the ROM.
2) Write data to the CPU module (flash
ROM).
3) Back up data to the flash card.
4) Write image data to an external device,
such as a memory card writer.
If the same error code is displayed again, the
cause is a failure of the memory card or SD
memory card. Please consult your local
Mitsubishi representative.
• Format the SD memory card.
• Reformat the SD memory card.
• QnUDVCPU: Remove the SD memory card
and insert it again.
• Replace the SD memory card.
Write the QCPU file the Flash card
• Format SRAM card after changing battery
of SRAM card.
• Before operation, set the parameter for the
file register to "Not available" and write it to
the CPU module.
• Format the memory card or SD memory
card.
• Reformat the memory card or SD memory
card.
• Check the memory card or SD memory
card.
• Do not insert or remove an extended
SRAM cassette during operation.
• Check that the extended SRAM cassette is
securely installed to the CPU module.
• If the same error code is displayed again,
the cause is a failure of the extended
SRAM cassette. Please consult your local
Mitsubishi representative.
LED status, Corresponding
CPU status
Qn(H)
QnPH
QnPRH
LCPU
RUN: Off/On
ERR.:Flashing/On
QnUDV
CPU Status:
*1
Stop/Continue
Qn(H)
QnPH
QnPRH
QnU (except
QnUDV)
RUN: Off/On
Qn(H)
ERR.:Flashing/On
QnPH
QnPRH
CPU Status:
*1
LCPU
Stop/Continue
RUN: Off
ERR.:Flashing
QnUDV
CPU Status:Stop
CPU
QnU
QnU
QnU