Mitsubishi Electric Q26UD(E)HCPU User Manual page 349

Error
Error and cause
code
[RESTORE ERROR]
• The system file does not exist in the backup
data to be restored.
• File(s) in the system file information does not
exist in the folder of the backed up data.
2230
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[RESTORE ERROR]
The data which is same as the one set the file
password 32 is restored to the restoration
destination CPU module.
2231 ■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[RESTORE ERROR]
• The folder with the setting values of SD919 to
SD921 (Restoration target folder) does not exist
in the SD memory card.
• The setting value of SD917 (Restoration target
2232
data setting) is out of range.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[RESTORE ERROR]
Automatic restoration is executed while no SD
memory card is inserted.
■Collateral information
2233
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[RESTORE ERROR]
• Automatic restoration is executed while the
memory size exceeds the maximum capacity of
the CPU module.
• Automatic restoration is executed while the
number of files exceeds the number of storable
2234
files of the CPU module.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[RESTORE ERROR]
The CPU module status (such as programs,
parameters, and file structure) of restoration
destination is different from the status at the time
of backup.
2235
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[LOAD ERROR]
The model of the load-destination CPU module is
different from that of the load-source CPU module.
■Collateral information
2240
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
Corrective action
Restore with any other backup data because
the backup data may have been corrupted.
To use the CPU module data
backup/restoration function, delete the file
password 32 setting and then execute the
function.
• Check and correct the setting value of
SD919 to SD921 (Restoration target
folder), and then execute the processing
again.
• Check and correct the setting value of
SD917 (Restoration target data setting)
and execute the processing again.
Insert or re-insert the SD memory card and
then execute the processing again.
• Check the size of restoration target data so
that it will not be larger than the memory
capacity, and execute the processing
again.
• Check the number of files so that it will not
exceed the number of storable files, and
execute the processing again.
• Restore the data with the CPU module
status at the time of backup.
• Set SD917 (Restoration target data setting)
to all the target data of backup and
restoration and then restore the data.
Execute auto loading using the same model
as that of the load-source CPU module.
APPENDICES
LED status, Corresponding
CPU status CPU
RUN: Off
ERR.:Flashing
QnUDV
CPU Status:Stop
RUN: Off
ERR.:Flashing
QnUDV
CPU Status:Stop
RUN: Off
ERR.:Flashing
QnUDV
CPU Status:Stop
RUN: Off
ERR.:Flashing
QnUDV
CPU Status:Stop
RUN: Off
ERR.:Flashing
QnUDV
CPU Status:Stop
RUN: Off
ERR.:Flashing
QnUDV
CPU Status:Stop
RUN: Off
ERR.:Flashing
LCPU
CPU Status:Stop
A
347