Mitsubishi Electric Q26UD(E)HCPU User Manual page 375

Error
Error and cause
code
[REMOTE PASS. ERR.]
The start I/O number of the remote password
target module is set to other than 0
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset/STOP  RUN
[REMOTE PASS. ERR.]
The start I/O number of the remote password
target module is set to other than 0
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset/STOP  RUN
[REMOTE PASS. ERR.]
3400
The start I/O number of the remote password
target module is not in the following range.
• Q00JCPU: 0 to 1E0
H H
• Q00CPU/Q01CPU: 0
H
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset/STOP  RUN
[REMOTE PASS. ERR.]
The start I/O number of the remote password
target module is out of range.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset/STOP  RUN
[REMOTE PASS. ERR.]
There is a problem in the slot specified by the start
I/O number of the remote password target module:
• No module is mounted.
• A module (such as I/O module) other than
intelligent function modules is mounted.
• An intelligent function module other than a serial
communication module or Ethernet module is
mounted.
• The function version of a serial communication
module or Ethernet module mounted is A.
• An intelligent function module that does not
support the use of remote password is mounted.
■Collateral information
• Common information: -
3401
• Individual information: -
■Diagnostic timing
• At power-on/At reset/STOP  RUN
[REMOTE PASS. ERR.]
There is a problem in the slot specified by the start
I/O number of the remote password target module:
• No module is mounted.
• An intelligent function module other than a serial
communication module or Ethernet module is
mounted.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset/STOP  RUN
to 0FF0
H H
Set the start I/O number within the range, 0
to 0FF0
H
to 07E0 .
H H
Set the start I/O number within the range, 0
to 07E0
H
Set the start I/O number within the following
range.
to 3E0
H
• Q00JCPU: 0
• Q00CPU/Q01CPU: 0
Correct the start I/O number.
Mount the following modules in the slot
specified by the start I/O number of the
remote password target module.
• Serial communication module whose
function version B or later
• Ethernet module whose function version B
or later
Mount an intelligent function module that
supports the use of remote password in the
specified slot.
Corrective action
H
.
H
.
to 1E0
H H
to 3E0
H H
APPENDICES
LED status, Corresponding
CPU status CPU
Qn(H)
QnPH
QnPRH
QnU
Q02UCPU
RUN: Off
ERR.:Flashing
CPU Status:Stop
Q00J/Q00/Q01
LCPU
Qn(H)
QnPH
QnPRH
QnU
RUN: Off
ERR.:Flashing
CPU Status:Stop
LCPU
A
373