Mitsubishi Electric Q26UD(E)HCPU User Manual page 545

Number Name Meaning
Project data Project data
SD636 batch load batch load
error cause error cause
Project data Project data
SD637 batch load batch load
status status
Directory Directory
batch delete batch delete
SD638
completion completion
status status
Directory Directory
batch batch
SD639
deletion deletion
status status
File register
SD640 Drive number
drive
Explanation
This register stores the cause of an error occurred when the
batch load function is executed.
• 0 : No error
H
• 800 : Mismatch of CPU module models
H
• 801 : Batch-save/load-target data read error (SD memory
H
card)
• 802 : SD memory card removed
H
• 803 : No system file (SVLDINF.QSL) existed
H
• 804 : Mismatch of file password 32
H
• 805 : No specified folder existed or specified number out-
H
of-range
• 810 : Load-destination drive write error
H
• 820 : Load error of a file in use
H
• 821 : Format was executed while a file that is being used
H
existed.
• 900 : SD memory card not inserted
H
• 901 : Use of SD memory card stopped
H
• A00 : Load-target data size exceeded the capacity of drive
H
or memory card
• B00 : Write protection set to SD memory card
H
• C00 : The batch load function was executed during the
H
latch data backup to the standard ROM.
• C01 : The batch load function was executed during online
H
change.
• C02 : The batch load function was executed with an FTP
H
client connected to and communicated with the CPU
module.
• C04 : The batch load function was executed while the CPU
H
module change function with SD memory card was being
executed.
• C07 : The batch load function was executed while the iQ
H
Sensor Solution function (data backup/restoration) was
being executed.
• C08 : The batch save function was executed while the file
H
transfer function (FTP client) was being executed.
• C10 : CPU module in RUN or PAUSE status
H
This register stores the current status of the batch load
function.
• 0 : Not executed
H
• 1 : Being executed
H
• 2 : Completed
H
• FF : Error
H
This register stores the completion status of the directory
batch delete processing.
0: Normally completed
Other than 0: Error code
When the delete processing is instructed, "0" is set.
The status of the directory batch delete processing is
indicated in percentage (0 or 100 %).
• When the delete processing is instructed, "0" is set.
This register stores the number of a drive storing a file
*1
register.
*1 For the QnUDVCPU or LCPU, this register is fixed at
drive 3.
APPENDICES
Corresponding
Set by Corresponding
ACPU
(When Set)
D9
S (Error) New
S (Status
New
change)
S (Writing) New
S (Writing) New
Q00J/Q00/Q01
S (Status
New
change)
A
CPU
*5
LCPU
*5
LCPU
QnUDV
QnUDV
Qn(H)
QnPH
QnPRH
*3
QnU
LCPU
543