Mitsubishi Electric Q26UD(E)HCPU User Manual page 650

Function
Writing/reading data to/from refresh devices by specifying a
*2
station number
( MELSEC-Q/L Programming Manual (Common
Instruction))
High-speed interrupt function
*7
Data logging function (
Manual (Data Logging Function))
IP packet transfer function (for CC-Link IE Controller Network)
( QnUCPU User's Manual (Communication via Built-in
*2*6
Ethernet Port))
Use of file registers in communication using the A-compatible
1E frame (MC protocol) through built-in Ethernet port
( QnUCPU User's Manual (Communication via Built-in
Ethernet Port))
Increase in the number of routing parameters
( MELSEC-Q/L Programming Manual (Common
*2
Instruction))
Latch clear by using the special relay and special register
*1*2
areas
Predefined protocol function
Reading/writing device data from/to the CPU module on
another station by specifying an IP address (
User's Manual (Communication via Built-in Ethernet Port))
iQ Sensor Solution function (data backup/restoration only) for
AnyWireASLINK and CC-Link (
*2
Reference Manual)
iQ Sensor Solution function (data backup/restoration only) for
CC-Link IE Field Network (
*2
Reference Manual)
MELSOFT connection extended setting (
User's Manual (Communication via Built-in Ethernet Port))
CPU module data backup/restoration function
Upper limit value setting for the number of backup data (CPU
module data backup/restoration function)
Retrying the automatic backup (CPU module data
*1*7
backup/restoration function)
iQ Sensor Solution function (automatic detection of connected
device, system configuration check, communication setting
reflection, sensor parameter read/write, monitoring, and data
backup/restoration) for built-in Ethernet (
*2
Solution Reference Manual)
CC-Link IE Field Network Basic function (
Field Network Basic Reference Manual)
SLMP frame send instruction (
(Communication via Built-in Ethernet Port))
648
*1*7
QnUDVCPU/LCPU User's
QnUCPU
iQ Sensor Solution
iQ Sensor Solution
QnUCPU
*2
*1*7
*1*7
iQ Sensor
CC-Link IE
*7
QnUCPU User's Manual
*2
Function Serial number
version (first 5 digits)
*11
---
---
"14022" or later
*9
*10
"15043" or later
(QnUDVCPU
only)
"15103" or later
"16043" or later
B
"17012" or later
"17052" or later
"17103" or later
"18052" or later
"18072" or later
"18112" or later
Programming tool version
GX Works2 GX Developer
--- ---
Version 1.98C or
×
later
Version 1.98C or
×
later
Version 1.98C or
×
later
--- ---
1.501X or later ×
1.513K or later ---
1.530C or later ---
× ---
1.535H or later ×
--- ---
--- ---
1.550Y or later ---
1.555D or later ×
--- ---