Mitsubishi Electric Q26UD(E)HCPU User Manual page 173

Item
Program memory
Memory card (RAM)
Memory Flash card
Max. number
card
ATA card
of files stored
(ROM)
Standard RAM
Standard ROM
Initial
Max. number of intelligent
setting
function module parameters
Refresh
No. of times of writing data into the
program memory
No. of times of writing data into the
standard ROM
No. of I/O device points
(No. of points usable on program.)
No. of I/O points
(No. of points accessible to the actual I/O
module.)
*7
Internal relay [M]
*7
Latch relay [L]
*7
Link relay [B]
*7
Timer [T]
*7
Retentive timer [ST]
*7
Counter [C]
*7
Data register [D]
Extended data register [D]
*7
Link register [W]
Extended link register [W]
*7
Annunciator [F]
*7
Edge relay [V]
*7
Link special relay [SB]
*7
Link special register [SW]
Universal model QCPU
Q20UDHCPU Q26UDHCPU
Q20UDEHCPU Q26UDEHCPU
319 (When the Q3MEM-8MBS is used)
4 files (each one of the following files: file register file, local device file,
sampling trace file, and module error collection file)
256
8192 points (X/Y0 to 1FFF)
8192 points by default (M0 to 8191) (changeable)
8192 points by default (L0 to 8191) (changeable)
8192 points by default (B0 to 1FFF) (changeable)
2048 points by default (T0 to 2047) (changeable)
(Sharing of low- and high-speed timers)
The low- and high-speed timers are specified by the instructions.
The measurement unit of the low- and high-speed timers is set up by parameters.
(Low-speed timer: 1 to 1000ms, 1ms unit, 100ms by default)
(High-speed timer: 0.01 to 100ms, 0.01ms unit, 10.00ms by default)
0 points by default (sharing of the low- and high-speed retentive timers) (changeable)
The low- and high-speed retentive timers are specified by the instructions.
The measurement unit of the low- and high-speed retentive timers is set up by parameters.
(Low-speed retentive timer: 1 to 1000ms, 1ms unit, 100ms by default)
(High-speed retentive timer: 0.01 to 100ms, 0.01ms unit, 10.00ms by default)
Normal counter, 1024 points by default (C0 to 1023) (changeable)
12288 points by default (D0 to 12287) (changeable)
0 points by default (changeable)
8192 points by default (W0 to 1FFF) (changeable)
0 points by default (changeable)
2048 points by default (F0 to 2047) (changeable)
2048 points by default (V0 to 2047) (changeable)
2048 points by default (SB0 to 7FF) (changeable)
2048 points by default (SW0 to 7FF) (changeable)
Q50UDEHCPU
*4
252
288
511
4096
2048
*5
Max. 100000 times
*6
Max. 100000 times
4096 points (X/Y0 to FFF)
131072 points by default (changeable)
CHAPTER 6 CPU MODULE
Q100UDEHCPU
512
171
6