Mitsubishi Electric Q26UD(E)HCPU User Manual page 540

(6) Drive information
Number Name Meaning
Memory card
types
Memory
SD600
card types
SD memory
card types
Drive 1
(Memory Drive 1
SD602
card RAM) capacity
capacity
Drive 2
(Memory
card ROM)
capacity
Drive 2
SD603
capacity
Drive 2
(Memory
card SD)
capacity
Memory Memory card
SD604 card use use
conditions conditions
538
Explanation
This register stores a value indicating the type of used
memory card in the following bit pattern.
b15 to b8 b7 to b4 b3
0
Drive 1
(RAM) type
Drive 2
(ROM) type
*1 For the Q00UJCPU, Q00UCPU, and Q01UCPU, the
drive 1 (RAM) type and drive 2 (ROM) type are fixed at
"0".
This register stores a value indicating the type of used
memory card in the following bit pattern.
b15 to b8 b7 to b4 b3
0
Drive 1
(RAM) type
Drive 2
(SD) type
This register stores the drive 1 storage capacity (unit: 1K
byte). (Free space value after formatting is stored.)
This register stores the drive 2 storage capacity (unit: 1K
*1
byte).
*1 For the Q2MEM-8MBA, a value stored to this register
depends on the product control number of the ATA card.
For details, refer to the following.
User's Manual (Hardware Design, Maintenance and
Inspection) for the CPU module used
This register stores the drive 2 storage capacity (unit: 1K
byte). (Free space value after formatting is stored.)
If the capacity is 32768K bytes or more, the stored value will
be 32767K bytes.
This register stores the usage status of a memory card in the
following bit pattern. (Each bit is on while the memory card is
being used.)
b0 : Boot operation (QBT) b8 : Not used
b1 : Parameters (QPA) b9 : Error history (QFD)
b2 : Device comments (QCD) b10 : Not used
b3 : Device initial value (QDI) b11 : Local device (QDL)
b4 : File register (QDR) b12 : Not used
b5 : Sampling trace (QTD) b13 : Not used
b6 : Not used b14 : Not used
b7 : Not used b15 : Not used
Set by
(When Set)
to b0
0: Does not exist
*1
1: SRAM card
0: Does not exist
(1: SRAM)
*1
2: ATA card
3: Flash card
S (Initial
and card
removal)
to b0
0: Does not exist
(Fixed to 0)
0: Does not exist
4: SD memory card
S (Initial
and card
removal)
S (Initial
and card
removal)
S (Status
change)
Corresponding
Corresponding
ACPU
CPU
D9
Qn(H)
QnPH
QnPRH
QnU (except
QnUDV)
New
QnUDV
LCPU
Qn(H)
QnPH
QnPRH
New
*2
QnU (except
QnUDV)
Qn(H)
QnPH
QnPRH
*2
QnU (except
QnUDV)
New
QnUDV
Qn(H)
New QnPH
QnPRH