Table 4-3 Pz-Bs10/Pz-Bs11 Connector Pin-Out - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
4 - 26
The PZ-BS10 connects the Controlling Chassis to the Expansion
Chassis by connecting to a PZ-BS11, which is installed on each
Expansion Chassis. These Expansion Interface Units allow the CPU
to transmit/receive data as required to the additional chassis.
The PZ-BS10 is installed in the EXIFU slot of the Controlling Chassis
which is equipped with a CPU card. The PZ-BS11 is installed in the
expansion slot of the Expansion Chassis, which does not have a CPU.
The EXIFU cable connects the Controlling Chassis and its EXIFU-B1
interface to the second, third, and fourth EXIFU-E1 interface.
Use only the CAT 5 cables provided by NEC to make the connections
between the Controlling and Expansion Chassis.
The PZ-BS10 provides:
Communication Processor Interface for data handling through
Communication Channel (24 slots maximum)
64 Channels for Telephony Resource (e.g., DTMF Tone Receiver,
Call Progress Tone Detector, MFC Tone Receiver, Caller ID
Receiver, Caller ID Signal Sender)
DSP Resource Management
3.5.4.1 Connector Pin-Out on the PZ-BS10/PZ-BS11

Table 4-3 PZ-BS10/PZ-BS11 Connector Pin-Out

3.5.4.2 Install the PZ-BS10 Expansion Base Blade in the
CHS2U-AU Controlling Chassis
1. Ensure the chassis is powered down.
UNIVERGE SV8100/SV8300
RJ-61 Cable Connector
PZ-BS10 – CN2, CN3, CN 4
PZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Do not remove or install this blade with
the power on.
Installing the SV8100 Chassis
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)