Table 5-2 Pz-Bs10/Pz-Bs11 Connector Pin-Out - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
5 - 36
Use only the CAT 5 cables provided by NEC to make the connections
between the Controlling and Expansion Chassis.
The PZ-BS10 provides:
Communication Processor Interface for data handling through
Communication Channel (18 slots maximum)
64 Channels for Telephony Resource (e.g., DTMF Tone Receiver,
Call Progress Tone Detector, Caller ID Receiver, Caller ID Signal
Sender)
DSP Resource Management
3.5.5.1 Connector Pin-Out on the PZ-BS10/PZ-BS11

Table 5-2 PZ-BS10/PZ-BS11 Connector Pin-Out

3.5.5.2 Install the PZ-BS10 Expansion Base Blade in the
CHS1U-AU Controlling Chassis
UNIVERGE SV8100/SV8300
RJ-61 Cable Connector
PZ-BS10 – CN2, CN3, CN 4
PZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Installing the SV8300 Chassis
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)