Ada-L( ) Unit; Figure 10-47 Nec Terminal Connection To An Ieee 802.3Af Poe Switch - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300

Figure 10-47 NEC Terminal Connection to an IEEE 802.3af PoE Switch

12.3
System Hardware Manual
3. Connect the NEC VoIP telephone to the TEL connector on the
ILPA-R( ) adapter with the LAN cable provided with the adapter.
If a customer-provided cable is used, the total length from
the switch to the telephone should be less than 328 feet.
The adapter can be positioned either closer to the multiline
terminal or switch – it does not matter.
4. Connect a cross-over LAN cable to the LAN connector on the
ILPA-R( ) adapter. Plug the opposite end into the switch which is
to provide power to the telephone. Refer to
Terminal Connection to an IEEE 802.3af PoE
If a straight-through cable is used, NIC Auto Detection must
be enabled in Programs 10-12-05 (CD-CP00-AU), 84-05-
02 (VOIPU) or 85-01-03 (SHUBU).

ADA-L( ) Unit

Using the ADA-L( ) Unit (Ancillary Device Adapter) provides a recording jack
connection from a telephone to an external tape recorder, speaker or PC. Both
sides of the conversation are recorded. The adapter output is a 1/8" audio
(stereo) jack which you can connect directly to an AUX level input on a recorder
or page amplifier.
Recording a conversation (Handset/Headset/Hands-free), or sending recorded
calls to a telephone are possible by connecting a cassette recorder to the
ADA-L( ) Unit (voice recording and the playback of a recorded sound from a
cassette recorder cannot occur at the same time).
Issue No. 1.5
Figure 10-47 NEC
Switch.
10 - 59