Vsr Application Software; Vsr User Interface Tab Options - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
10 - 30
4. The software is fully tested, but has not yet been submitted to Microsoft
for approval. Press Continue Anyway.
5. Press Finish to close the dialog box.
6. Run SBladep.exe on your NEC Installation CD to install the D
Security Recorder application software on your PC.
7. Using the USB cable provided, connect the USB interface of the NEC
VSR unit to an available USB port on your PC.
8. Unplug the line cord from your telephone and connect the phone to either
term
port on the D
9. Connect the NEC telephone system to the remaining port on the D
VSR unit (refer to
page 10-39).
11.3.1

VSR Application Software

The VSR software is delivered on a Compact Disk using a self-starting
install shield. The CD contains all applicable files and installation
procedures to operate to this specification, including USB device
drivers, software application, and Help files.
A quick-start instruction sheet and a prerecorded user guide that steps
the user through the various options are provided.
The VSR application supports Microsoft Operating Systems that
support USB devices. The following systems meet this requirement:
WIN 98SE
WIN Millennium Edition (ME)
WIN 2000
WIN XP (all variants)
VSR does not support WIN 95 and below, or WIN NT.
11.3.2

VSR User Interface Tab Options

VSR has the following tabs to allow the user to select features and
options:
Playback allows various playback features of recorded
conversations.
Record allows control of recording.
About provides software version information.
Options to set-up controls such as recording format.
VSR unit.
Figure 10-34 Voice Security Recorder Connection on
Installing SV8100/SV8300 Optional Equipment
UNIVERGE SV8100/SV8300
term ®
Voice
term