UNIVERGE SV8100/SV8300
System Hardware Manual
3.2.2
Multiple CHS2U-AU Chassis Installation
Expansion chassis can be secured to the CHS BASE UNIT and will
require an additional CHS2U JOINT BRACKET KIT per chassis.
1.
Install the five rubber feet to the bottom of each chassis.
2.
Using supplied screws, attach joint brackets to both ends of the
19" chassis and the CHS BASE UNIT. Refer to
Install Joint Brackets with Screws on page
3.
Connect the ground wire to all chassis. Refer to
Chassis Grounding on page 5-45
grounding the system.
4.
Refer to
installation of the chassis or, Chapter 5 paragraph
an Extension or Trunk Blade on page 6-3
blades.
Figure 5-18 Install Rubber Feet (Multiple Chassis)
Figure 5-19 Install Joint Brackets with Screws
3.5 Installing the 19" Chassis on page 5-33
Issue No. 1.5
Figure 5-19
5-19.
Joint
Bracke
3.5.7 Install 19"
for complete details on
to continue
2.2 Installing
for installation of
5 - 19