UNIVERGE SV8100/SV8300
SW6-1
SW6-2
SW6-3
SW6-4
RUN (LED1)
Blinking
Blinking
System Hardware Manual
Table 6-6 CD-CP00-AU Switch 6 Settings
Configuration
OFF
ON
OFF
ON
3.1.4
LED Indications
The LEDs on the CPU indicate the following:
RUN (LED 1) = The CPU is operating (green)
LED 2, and 3 = Alarms (red)
LED 4 = Flash access indication (red)
LED 5 = The USB memory connection status (red)
(LED off when no USB memory installed)
Refer to Program 90-10: System Alarm Setup for details on
assigning alarm LEDs.
Table 6-7 CD-CP00-AU LED Indications on page 6-19
of each LED and associated operation and status indications. Refer
to
Figure 6-3 CD-CP00-AU Blade Layout on page 6-13
of the LEDs on the CD-CP00-AU.
Table 6-7 CD-CP00-AU LED Indications
LED Indication
LED2
LED3
Off
Off
Off
Off
Off
Off
On
Off
Blinking
Off
Off
On
On
Not Used
Test Mode
ON = Test Mode
OFF = Normal
RS232C Select
ON = Use
OFF = Not Used
Reset Configuration
ON = Normal
OFF = ICE Mode
LED4
LED5
Off
On Steady When
USB Memory is
Installing
Off
Blinking
Off
Off
Access
On Steady When
Blink
USB Memory is
Installing
Access
On Steady When
Blink
USB Memory is
Installing
Issue No. 1.5
Note
provides a list
for the location
Status
System operating normally
Boot is starting
Initializing the disk or
formatting
Boot program is initializing in
the flash memory
Reading system software
6 - 19