Figure 10-36 Digital Station Ports - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
11.5.6.3 Install the 4-Port Digital Call Logging Unit
1. Connect the 4-Port Digital Call Logging Unit device to
the USB cable and plug the USB cable into the PC.
Windows responds with the Found New Hardware
wizard.
2. Insert the provided NEC BackOffice CD into the CD
drive of the PC.
Direct the installation of the driver to Specific
Location and specify the Driver folder on the CD.
Windows should find and load the device driver.
3. Before inserting the next USB cable, restart the
PC. If Windows responds with Found New Hardware
again, direct to the CD a second time and restart the
PC. Once you get a clean restart and Windows
recognizes the device on restart, install the next
device.
4. Leave the CD in the CD drive and connect the next
device, you may need to direct windows to the CD
with each device you connect. Also, you may need to
restart the PC with each device connection (this may
require two restarts per device).
5. Once all devices are connected, restart the PC and
view the devices in Device Manager to ensure proper
installation.
6. Connect the telephone wiring to the 4-Port Digital
Call Logging Unit. Be sure to note which extension is
connected to which port of the devices (each device
has a unique serial number). In the Recorder window
you will see the serial number followed by a trailing
digit (1 ~ 4), this identifies the port on the device.
Before the telephone wiring is connected, the devices may
temporarily show Failed and then reinitialize. This is
normal operation.
Label each Digital Station Port with the extension it
will be recording. Refer to
Ports.

Figure 10-36 Digital Station Ports

Issue No. 1.5
Figure 10-36 Digital Station
10 - 43