Removing The Base Plate; Figure 11-24 Raising The Height On The Dth/Dtr Multiline Terminal; Figure 11-25 Lowering The Base Plate On The Multiline Terminal - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
1.
2.
3.
R
S 10
EMOVING OR
ECTION
T
ERMINAL
DTH/DTR multiline terminals come equipped with a base cover.
10.1
System Hardware Manual
Grasp in the middle of the hollow spaces at the top and pull up until the retaining
tabs click to raise the base plate. Refer to
DTH/DTR Multiline Terminal.

Figure 11-24 Raising the Height on the DTH/DTR Multiline Terminal

After the height is adjusted, pull the line cord though the groove in the bottom of
the multiline terminal and adjust it.
Push on the adjustment tabs on the side of the stand and push down to lower the
base plate. Refer to Figure 11-25 Lowering the Base Plate on the Multiline
Terminal.

Figure 11-25 Lowering the Base Plate on the Multiline Terminal

I
NSTALLING THE

Removing the Base Plate

1. Extend the base plate to maximum height.
Figure 11-24 Raising the Height on the
B P
ASE LATE ON A
Issue No. 1.5
M
ULTILINE
11 - 15